Model Q & U Master Cylinder - November 19,
2006 Back
I removed the master cylinder and dissembled the internal
parts.
The rubber parts were in good shape. No dry rot.
I am pretty sure that parts 13 through 19 are the same as
the PA, PB, PC, and PD
It appears that the rear chamber was tack welded so that it
could not be removed. The owners manual remarks that the
cylinder is not repairable and should be replaced if faulty.
I ground off the weld but still couldn't unscrew the rear
assemble.
I will soak it in solvent and clean it out with compressed
air.
